2、Temperature separation: the feeding mouth of the constant temperature heating section USES automatic rising and falling separation hot;The feeder of constant temperature heating section and cooling section USES automatic lift and drop to separate hot, sharing one automatic lift and drop to separate hot;Automatic lifting and separating hot spots for the discharge port of cooling section;
3、the heating temperature range: at room temperature to 100 ℃ is adjustable, set up two constant temperature heating zone (temperature detection and display, setting, independent temperature control,respectively).

4、cooling temperature: room temperature - 35 ℃, setting a cooling zone (with temperature detection and display);

5、Temperature record: the thermostatic heating section contains 6 temperature detection points (front, middle and back and both sides), record the temperature detection data, and the detection frequency can be adjusted (0-60min).

6、Equipment direction: face the operating surface, right hand in and left hand out.

7、Continuous working time: continuous working time is greater than or equal to 120h;

1、Shell material: Q235 cold-rolled steel plate, bending and welding of sheet metal;Surface polishing, polishing and phosphating treatment;High temperature plastic spraying;

2、Inner liner material: SUS304 stainless steel plate, sheet metal bending welding;Surface polishing and polishing treatment;

3、Duct material: SUS304 stainless steel plate, sheet metal bending welding;

4、Insulation material:Silicate fiber cotton of 100K high-density aluminum , 100mm thick;

5、surface temperature, constant temperature heating work after 2 h, the surface temperature is less than or equal to 35 ℃.

6、Maintenance: repair can be carried out by clamping cover, and electrical cover can be clamped;