2、Dimension：W2700*H3710*D2320；

3、Temperature range:Equipment within 300 ℃ is adjustable；

4、Temperature fluctuation：≤±1℃；

5、Temperature uniformity：≤±3℃(no load)；

6、Heating rate：≤8℃/min  Within 30 minutes from room temperature to 250 ℃；

7、The shell temperature: equipment within 300 ℃, the surface temperature is not higher than room temperature ' 10 ℃, the seams around the door, and in addition to;
8、Circulating air mode: a large number of forced air circulation from the upper and lower circulation;

9、Power supply: three-phase five-wire system，380V，50HZ；

10、Total power：95KW 。

1、Shell material: 2mm thick Q235 cold rolled steel sheet (the best comprehensive performance of strength, plasticity and welding) with high temperature drying plastics (anti-static and anti-corrosion);

2、Inner liner material: 0.8mm galvanized sheet is used, and the air transport layer is made of 430 stainless iron. The inner liner should be clean, free from dust, rust and corrosion, and easy to clean.

3、Chamber frame: the chamber body is made of 50*50*3mm Angle iron to maintain the bearing strength of each internal and external surface of the chamber, and keep the heat expansion and cold shrinkage coefficient to prevent the chamber body from deformation.

4、Sealing material: the sealing strip is made of silica gel, which can withstand temperature without deformation, and the door and inner tank are double-layer sealed to enhance the sealing effect;

5、Door: the upper part of the chamber is provided with air inlet and air outlet adjusting valves;Φ 110 mm diameter, adjustable air flow, make the furnace temperature is uniform;The exhaust port is equipped with a 0.75kw centrifugal fan and 1HP frequency converter for speed adjustment, and the air volume can be adjusted.

1、Air motor: 4 edeley 1.5kw air motor in Taiwan, equipped with adeli frequency converter;

2、Wind wheel: 4 pieces of 14-inch multi-wing stainless steel air wheel;

3、Heating pipe: adopt stainless u-type heating pipe with radiator fin, which can make the temperature of heating pipe evenly distributed;

4、Air heating method: the air is filtered by the air inlet of the oven and then fed into the air groove of the heating pipe.The air is circulated in the oven after being heated and the waste gas is discharged from the exhaust port.

5、Pressure sensor: pressure sensor detects pressure difference inside and outside the furnace;

6、Time control: 6 kinds of time control Windows are integrated on the touch screen.

7、Temperature sensor: omron 3-meter standard, k-type thermocouple.

1、Automatic constant temperature: the thermostat can calculate the output power automatically with PID according to the temperature value set by the user;The closer to the temperature setting value, the smaller the output power to achieve the purpose of thermostatic control and energy saving.

2、Mechanical over-temperature meter: equipped with adjustable over-temperature meter with maximum temperature of 300 degrees, 

automatically cut off the heating power when the temperature reaches the set temperature.

3、Over-temperature alarm: when the actual detection temperature exceeds the setting value of the over-temperature protection thermostat, automatically cut off the heating power, playing dual protection function;

4、Concentration detector: VOC concentration detector is installed in the air outlet of exhaust motor, with two sections of output (20%, 50%). Flammable and explosive gas is detected, and the output signal is used to control the speed of exhaust motor.

5、Audible and visual alarm: alarm lamp with buzzer.