Drying precision oven of LED products moisture

2、Dimension（around）：W800*H1310*D530mm

3、Temperature range：Indoor temperature～250℃ adjustable；

4、Temperature fluctuation：≤±1℃；

5、Temperature uniformity：≤±3℃(no load)；

6、Heating rate：≤8℃/min；

7、Enclosure temperature：Enclosure temperature is not higher than room temperature'10℃，except for the seam around the door。

8、Air circulation mode: a large amount of forced air in horizontal circulation is greater than or equal to 300 cubic meters/h

9、Power supply: three-phase five-wire system, 380V, 50HZ;

10、Gross power：6KW

1、Shell material: it is made of 2mm thick Q235 cold-rolled steel sheet (with best strength, plasticity and welding comprehensive performance), which is bent and welded.

2、Inner material: made of 1.5mm thick SUS304 stainless steel plate to keep the tank clean and free of dust, rust and corrosion;

3、Enclosure frame: the enclosure body is made of 50*50*3mm Angle iron to maintain the bearing strength of each internal and external surface of the enclosure, and keep the heat expansion and cold shrinkage coefficient to prevent the enclosure body from deformation.

4、Sealing material: the sealing strip is made of silica gel, which can withstand temperature without deformation, and the door and inner tank are double-layer sealed to enhance the sealing effect

5、Move casters: 4 pieces of universal wheel with brake are installed at the bottom of the enclosure body to facilitate the movement and fixation of the oven.

1、Air motor: Taiwan adeli 0.37kw air motor;

2、Wind wheel:Multi-wing wheel in 9 inch;

3、Heating pipe: adopt u-shaped heating pipe of SUS304 stainless steel made in Taiwan, with heat radiator, which can make the temperature of heating pipe evenly distributed;

4、Time timer: record the total drying time of the oven

5、Control of heating tube: control each group of heating tube by SSR solid relay;

1、The ambient temperature：-5℃-40℃

2、Relative humidity：≤85%RH

3、Power supply：AC380V±10%，50Hz。